repair and apartment furnish
apartment repair apartment repair by the hands apartment repair - the main page apartment repair by own strength independent repair of apartment repair of the apartment
  >
 

Obojnye of work (a part 2)

the Label of wall-paper . Before gluing wall-paper is cut on pieces (panels) of the corresponding length, and it is necessary to watch pattern coincidence. .

Patterns of the next cloths will coincide when upper edges of panels begin with the same place of a pattern (fig. 13. If a pattern on wall-paper rare, it is necessary to cut off from a bottom edge of panels pieces in length 15-20 see

Often unnecessary edge of wall-paper is cut off even before paste drawing. In that case paste at drawing on panels gets under edges, i.e. On the top surface of wall-paper, leaving there stains. To cut off edges (edge) after paste drawing on panels more correctly. .

For drawing of paste of a panel of wall-paper are put by a face sheet downwards one on another on the table covered with paper for recycling. In case of absence of a table wall-paper is put on a floor. Then with the help maklovitsy or brushes wall-paper smears with paste (fig. 13, avoiding hit of the last on edges of panels of wall-paper located more low. For this purpose the top panel remove on 5-10 sm aside from the underlaying. Thus edges of underlaying panels are protected from paste. The best paste for gluing of wall-paper is flour paste without the glue additive but as this paste is capable to get through some grades of wall-paper, house painters apply basically starched paste. Paste penetration through wall-paper partially is interfered by application of half-baked flour paste. On obojnyh works it is possible to apply also synthetic glues. .

a Fig. 13. Gluing of wall-paper: about - a general view of pasted wall-paper, - paste drawing on wall-paper, in - bending of the ends of a piece of wall-paper and an edge scrap, g - razgibanie the top piece of wall-paper after scraps of edges, d - gluing of the top part of a piece of wall-paper on a wall, bending back and gluing of the bottom part of a piece

a Fig. 13. Gluing of wall-paper:
And - a general view of pasted wall-paper, - paste drawing on wall-paper, in - bending of the ends of a piece of wall-paper and an edge scrap, g - razgibanie the top piece of wall-paper after scraps of edges, d - gluing of the top part of a piece of wall-paper on a wall, bending back and gluing of the bottom part of a piece

On the basis of structure KMTS lets out synthetic glue for wall-paper. The instruction on its application is enclosed to glue.

After a covering paste both ends of a panel, on length of a quarter of a strip fold double (fig. 13, in, the parties smeared with paste inside then scissors cut off edge (an edge). Then one end of a panel is developed and established on a plumb on a wall corner so that the part of a panel in width about 3 sm acted through a corner. If the angular panel is established in vertical position also other panels will be vertically located. .

After gluing to a wall of the top part of a panel develop its bottom part. Then wall-paper is smoothed densely on a wall, a dry and pure rag (or the rubber platen) so that air which has remained under wall-paper left through panel edges (fig. 13.

The Label of wall-paper begin with a part of the wall located at a window, and it is necessary to watch that the cut off edge of a panel has been located in an incident light direction. Otherwise junctions of panels will be very appreciable. It is necessary for considering and at a scrap of edges of wall-paper. At gluing of wall-paper on a wall located to the right of a window (if to stand to it the person), it is necessary to cut off a left edge, beginning a label on the left side - a panel right edge. .

< the previous page - the following page >


All articles from section " Decorative furnish ё=хэ"